Circuit Breaker- Tripped
Circuit Breaker- Normal
Color LaserWriter 12/600PS-
Circuit Breaker Reset Procedures
In order to access the circuit breaker the rear plastic cover must be removed so that the main power supply is
exposed. The circuit breaker itself is hidden, but there is a small oval hole cut in the power supply sheet metal
which can be used to view whether or not the circuit breaker needs to be reset. Once the hole has been located
(see pictures below), check to see whether or not the yellow plastic indicator from the circuit breaker is visible. If
it is visible then the circuit breaker needs to be reset using the procedures listed below.
Circuit Breaker Access Hole
Procedure:
1) Remove the rear plastic cover to expose the main
power supply.
2) Use a small non-conductive wood or plastic probe
(i.e. toothpick, ball point pen cap) to gently move the
yellow plastic circuit breaker indicator to the right
until it is no longer visible.
3) Reinstall the plastic covers and test the printer. If
the printer continues to trip the circuit breaker then an
overload condition still exists. Consult the Service
Source troubleshooting documentation for additional
assistance.
Indicator- move to right to
reset the circuit breaker
