Step 2
• Parts Needed For •
Frame Assemblies
5986 Rear Wall Angle (2)
10389 Rear Wall Channel (2)
10390 Side Wall Channel (4)
10394 Side Wall Angle (4)
The main frame pieces reinforce the
walls. These pieces will later be in
stalled in the center and at the top
edge of the side walls and the rear
wall. Proceed as follows:
1 Overlap the rear wall channel
pieces as shown in the figure and
fasten the two pieces together with
eight bolts as shown.
2 Make two side wall channels by
overlapping the side wall channel
pieces as shown. Fasten each set
together with eight bolts as shown.
3 Overlap the rear wall angle
pieces as shown in the figure and
fasten them together with one bolt In
the center hole.
4 Make two side wall angles by
overlapping the side wall angle
pieces as shown. Fasten each set
together with one bolt thru the sec
ond large hole from the end of each
part.
5 Set the assemblies aside. You will
use them later.
Rear Wall Channel
1181/8" 300,0cm
10390
-Mil
I liHH'
I if
Side Wall Channels
140 3/8" 356,6cm
Rear Wall Angle
1181/8" 300,0cm
Side Wall Angles
140 3/8" 356,6cm
STEP
STEP
3
4
Rear Wall Channel 118 1/8" 300,0cm
Side Wall Channels 140 3/8" 356,6cm (2 Assemblies)
Rear Wall Angle 118 1 /8" 300,0cm
15
