30
CS-352
• Place the depth gauge tool rmly on guide bar so that
depth gauge protrudes. Then le top of depth gauge
with the at le until at with top of the depth gauge
tool.
• Be sure to round off the front edge of the depth
gauge.
Properly led cutters are shown in illustration.
When setting of the chain is nished, soak it in oil and
wash away lings completely before using.
• When chain has been led on the bar, supply suf-
cient oil to it, move the chain slowly to wash away the
lings before using again.
• If the chain saw is operated with lings clogged in the
groove, the saw chain and the guide bar will be dam-
aged prematurely.
• If the saw chain becomes soiled with resin, for in-
stance, clean it with kerosene and soak in it oil.
NOTE
These angles are referred to as 91PX. To sharpen
other follow chain manufacturer’s instruction.
1/5
One fth of le diameter remains
above cutter edge
Side plate angleTop plate ling angle
80°
30°
Parallel
0.64 mm
(0.025 in.)
Depth gauge
Remove until
at with tool
Depth gauge tool
Round off
the edge
