2.
Install the shelf supports.
9.3 Removing / inserting the
door
WARNING!
Be careful when you remove the
door from the appliance. The
door is heavy.
You can remove the door and the inter-
nal glass panels to clean it. The number
of glass panels is different for different
models.
A
A
Removing the door and the glass pan-
els
1.
Open the door fully.
2.
Fully press the clamping levers (A)
on the two door hinges.
3.
Close the door to the first opening
position (approximately 70° angle).
4.
Hold the door with one hand on
each side and pull it away from the
appliance at an up angle.
5.
Put the door with the outer side
down on a soft cloth on a stable sur-
face. This is to prevent scratches.
2
B
1
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
7.
Pull the door trim to the front to re-
move it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water
and soap. Dry the glass panel care-
fully.
Inserting the door and the glass
panels
When the cleaning is completed, install
the glass panels and the door. Do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger.
9.4 Lamp
WARNING!
Danger of electrocution! Discon-
nect the fuse before you replace
the lamp.
The lamp and the lamp glass
cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
22
www.aeg.com
