DMR100 User’s Guide V2.0
49
Command Line
The DMR100 has a Command Line interface that can be accessed from Telnet or RS-232. A list of
commands can be found in the External Control section of this manual.
Telnet (TCP/IP)
The Telnet port by default is not enabled. To turn on Telnet control, set the Telnet port number (typically
Port 23) and check the TCP/IP port enable checkbox. A password challenge to the Telnet session can
be enabled by entering a password in the Password for TCP/IP connection text box. If a password is
not desired on the Telnet session, leave the text box blank.
RS-232
On the back of the DMR100 there is a control port configured as a DTE supporting RS-232 protocol. A
Null-Modem cable should be used between the DMR100 and the COM port on your PC.
Terminal session settings required for RS-232 control are: 9600, 8, None, 1 with No Flow Control.
There is no password protection on this interface and, by default, the RS-232 port is enabled. The
administrator has the ability to disable the port by un-checking the COM port enable checkbox.
