Ribbon Replaced?
Y = Setup N = No
****This message will be displayed whenever the rear access cover is opened and then closed.
Pressing the Setup key (Y) in response to this message will cause the printer to reset the ribbon
usage feature to 0%, reset the carriage, and resume operation. Pressing the On Line (N) in response
to this message will cause the printer to reset the carriage and resume operation without effecting
the ribbon usage value. However, if the ribbon is at 100% usage, it must be replaced before printing
may continue.
2. Enter Setup mode and manually change the value of the ribbon usage feature to some value
less than 100%. For additional information on setting features, refer to Chapter 4 in the
User's Manual.
E-3
This page intentionally left blank.
