32918 1
© Copyright 2003, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without
the expressed written consent of the publisher.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Table of Contents
Section 1 – Safety Information
Locating an Authorized Servicer ............................4
Section 2 – Introduction
Customer Service ....................................................5
Nameplate Location ................................................5
Model Identification ................................................6
Section 3 – Troubleshooting
1. No Hot Water ...................................................7
2. No Cold Water .................................................7
3. No Warm Water ...............................................8
4. Water Fill Does Not Stop At Proper Level ......8
5. Timer Does Not Advance (Mechanical Timer
Models only) ....................................................8
6. No Agitation .....................................................9
7. Constant Agitation ...........................................9
8. Slow Spin Or No Spin ....................................10
9. Constant Spin .................................................10
10. Drive Motor Overload Protector Cycles
Repeatedly ......................................................10
11. Outer Tub Does Not Empty ...........................11
12. Excessive Vibration .......................................11
13. Water Leaking From Outer Tub ....................11
Section 4 – Grounding
14. Wall Receptacle Polarity Check ....................13
15. Power Cord to Control Hood, Control Hood to
the Control Panel Frame ................................13
16. Control Hood Wire Harness to Top Left Rear
Corner Gusset of Cabinet ...............................14
17. Motor to Mounting Bracket ...........................14
Section 5 – Service Procedures
18. Control Panel .................................................15
19. Speed or Wash Temperature Switch ..............15
20. Indicator Lights – Unbalanced Load, In Use,
Rinse or Spin ..................................................16
21. Timer Assembly – Metered Models ..............16
22. Timer Assembly (Nonmetered Models) ........17
23. Meter Case (Metered Models) .......................17
24. Timer Case (Nonmetered Models) .................18
25. Pressure Switch ..............................................19
26. Drain Hose Elbow ..........................................19
27. Loading Door .................................................20
28. Graphic Overlay .............................................22
29. Agitator ..........................................................22
30. Agitator, Drive Bell and Seal Assembly ........22
31. Front Panel .....................................................24
32. Pump Belt ......................................................25
33. Drive Belt .......................................................25
34. Motor and Mounting Bracket ........................26
35. Idler Lever and Pulley ....................................27
36. Motor Drive Pulley or Pump Pulley ..............29
37. Motor Switch .................................................29
38. Pump Assembly .............................................29
39. Cabinet Top Assembly ...................................30
40. Door/Out-Of-Balance Switch Assembly .......33
41. Mixing Valve Assembly ................................36
42. Washtub and Lint Filter or Clothes Guard .....37
43. Hub and Seal Kit Assembly ...........................42
To Install Drive Bell and No. 39508P
Seal Kit............................................................47
44. Outer Tub .......................................................48
45. Drive Pulley and Helix ..................................52
46. Brake Assembly .............................................53
47. Lower Bearing Housing .................................53
To Remove the Bearing ..................................56
48. Transmission Assembly .................................56
To Disassemble Transmission Assembly .......59
To Reassemble Transmission Assembly ........61
49. Balance Ring ..................................................62
50. Upper Bearing Assembly ...............................62
51. Snubber Pads ..................................................63
To Install the No. 434P3 Snubber Pad Kit......63
Section 6 – Adjustments
52. Leveling Legs ................................................67
53. Pressure Switch ..............................................68
54. Belt — Agitate and/or Spin ...........................68
55. Belt — Pump .................................................68
56. Out-of-Balance Switch Trigger – Through
Serial No. R8237277YK ................................69
