– 2 –
NTo connect to 2 single-line telephone jacks
1 For Line 1: Connect the “Transparent” plug telephone
line cord (2-wire cord) (1) to the unit, then to the Line
1 single-line telephone jack (RJ11C) (2) until you hear
a click.
2 For Line 2: Connect the “GREEN” plug telephone line
cord (4-wire cord) (3) to the unit, then to the Line 2
single-line telephone jack (RJ11C) (4) until you hear
a click.
Battery installation/Battery charging
Charge for about 7 hours.
Note:
LUSE ONLY Ni-MH batteries AAA (R03) size (1).
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.
LConfirm correct polarities (S, T).
LFollow the directions on the display to set up the unit.
LConfirm “Charging” is displayed (2).
Using the unit as a single-line telephone only
1 Connect the “Transparent” plug telephone line cord (2-wire
cord) to LINE 1/2.
Handset/Base unit:
LTo use line 1 only: {MENU}(25) s {r}: “Line1” s
{SAVE} s {OFF}/{EXIT}
LTo erase the message “Check tel line2”:
{MENU}(19)
Connecting the telephone line cord
2
4
3
12
1
“Transparent” plug
“GREEN” plug
1
2
1
If you subscribe to a DSL/ADSL service, attach a DSL/ADSL filter to the telephone line between the base
unit and the telephone line jack. Refer to the operating instructions for connections.
TG954x_(en)_QG.fm Page 2 Thursday, June 27, 2013 4:13 PM
