APPLIANCES
I - 10
I
Setting The Clock/Timer
You may set the clock timer at any time before or after brewing. When the unit is
plugged in, the clock will flash (12:00) AM. The clock will stop flashing in about
10 seconds after setting the clock. You can enter into the clock setting again by
pressing and holding the HR or MIN button for a few seconds.
To set the current time: Press the HR and MIN button until you reach the 1.
current time. You may hold the button down to reach the current time
quickly. AM or PM will appear on the left side of the display. When the
time is set, the display will keep flashing for a few seconds, then the clock
will start. To reset the time, press and hold the HR or MN button for a few
seconds, the clock will flash again, and then you adjust the time.
To set the auto time: Press the PROG button, the clock and PROG light 2.
will flash, Then press the HR and MIN buttons until you reach your desired
pre-set brewing start time. Press the PROG button again, the PROG light
will then stop flashing and stay on to indicate the function is activated. The
LCD will return to display the current time.
To cancel the Auto-on time, press the PROG button again and PROG light 3.
will turn off.
NOTE: You can stop the brewing cycle at any time when you press the ON/
OFF button once.
CLEANING
Clean the Coffee Maker
Be sure that the Coffee is unplugged and cool. Discard the paper filter and the
grounds, and clean as follows:
Thermal Carafe and Carafe lid are both top rack dishwasher safe; or they 1.
may be hand washed.
Filter Basket, Reservoir, and Reservoir Lid may be rinsed with water and 2.
cleaned with a soft damp cloth.
The unit may be cleaned with a soft damp cloth.3.
CaUTiOns:
Do not use abrasive cleaner or scouring pads.•
Never immerse the coffee maker into water or any liquid.•
Do not clean inner or outer surface of the Carafe with a hard •
tool.
Do not make coffee while under way. Hot liquid could scald due •
to a sudden stop or accident.
