2: HPX-2000-HP-DUV Specifications
4 000-10000-081-02-201207b
Front Panel
Component Description
Power LED Displays state of main power to lamp.
Xenon ON/OFF
Press and hold the ON/OFF switch for more than 1 second to turn the lamp
on or off.
Status LED
Status of the Xenon lamp:
• Lit – Xenon lamp is on
• Blinking – Lamp is in setup mode or cool down mode. The Lamp
cannot be started when the Status LED is blinking.
• Off – Xenon lamp is off
Shutter Switch
OPEN - Shutter open
CLOSE - Shutter closed
TTL - operation by external TTL- signal (HIGH=OPEN, LOW=CLOSE)
Mechanical Protection
– SMA Connector
Covered to protect users from unintentionally looking directly at the beam of
light. Used for SMA connections only. Connect the fiber cable to the HPX-
2000-HP-DUV BEFORE turning the lamp on to avoid unnecessary exposure
to UV radiation. Avoid direct contact with the fiber end.
Always wear proper eye protection when using the HPX-2000-HP-DUV lamp.
Four Recessed
Screws
Unscrew to remove the unit’s housing. See Bulb Replacement
.
(front and back sides)
Mechanical Protection –SMA
Connector
Power LED
