Aerco Brand's Products

3.6 Setting Jumpers

You may configure your card to match the needs of your application

by setting jumpers. A jumper is a metal bridge that closes an electrical

circuit. It consists of two metal pins and a small metal clip (often

protected by a plastic cover) that slides over the pins to connect them.

To "close" a jumper, connect the pins with the clip. To "open” a

jumper, remove the clip. Sometimes a jumper will have three pins,

labeled 1, 2 and 3. In this case, you would connect either pins 1 and 2,

or 2 and 3.

The jumper settings are schematically depicted in this manual as

follows:

A pair of needle-nose pliers may be helpful when working with

jumpers.

If you have any doubts about the best hardware configuration for

your application, contact your local distributor or sales representative

before you make any changes.

Generally, you simply need a standard cable to make most connec-

tions.

ClosedClosed

Closed

Closed 2 - 3Closed 2 - 3

Closed 2 - 3