11 Chapter 2
2.2 Installation Procedures
2.2.1 Connecting the power cord
The panel PC can only be powered by a DC electrical outlet
(16Vdc~25Vdc, 3.5A max.). Be sure to always handle the power cords by
holding the plug ends only. Please follow the figure 2-5 to connect the
male plug of the power cord to the DC inlet of the panel PC.
2.2.2 Connecting the keyboard or mouse
Before you start the computer, please connect the Y-shaped adaptor to the
PS/2 mouse and keyboard port on the I/O section of the panel PC, then
connect the necessary mouse or keyboard to the Y-shaped adapter or
serial ports.
2.2.3 Switching on the power
When you look at the right side of the panel PC, you will see the power
switch as shown in Figure 2-6 and Figure 2-7. When the switch is on hor-
izontal position as Figure 2-6, it is in lock status. You can set it to avoid
accidental open or close of the computer. When the switch is on vertical
position as Figure 2-7, it can be pushed to open or close the computer.
Figure 2.5: Connecting the power cord to the DC inlet
DC inlet
AC/DC power adapter
