24
Malfunction Possible cause Remedy
1 short warning tone
continuously repeated can
be heard,
the cycle indicator for the
selected dishwashing cycle
is flashing:
the control indicator
lights up:
fault code
Å10 is dis-
played in the multi-dis-
play:
(Problems with water in-
let)
Water tap is blocked with
limescale or faulty.
Check the water tap and
have it repaired if necessary.
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
dishwasher compartment
are blocked.
Press the button for the
commenced dishwashing
cycle;
then abort the dishwashing
cycle (see section: Starting a
dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Water inlet hose
has not been correctly posi-
tioned.
Check the position of the
hose.
2 short warning tones
continuously repeated can
be heard.
The cycle indicator for the
selected dishwashing cycle
is flashing,
fault code
Å20 is dis-
played in the multi-dis-
play. (Problems with water
outflow)
The sink outlet is blocked. Clean out sink outlet.
Water drain hose
has not been correctly posi-
tioned.
Check the position of the
hose.
3 short warning tones
continuously repeated can
be heard,
Fault code
Å30 is dis-
played in the multi-dis-
play.
The anti-flood system has
been triggered.
First shut off the water tap,
then switch off the appli-
ance and contact the Cus-
tomer Care Department.
The cycle is not starting.
The mains plug is not
plugged in.
Plug in mains plug.
A fuse in the house’s wiring
system is defective.
Replace fuse.
For dishwasher models with
a delay start timer:
A start time has been se-
lected.
If the dishes are to be
washed immediately, cancel
the delay start.
