USER’S MANUAL OF WNAP 3G MOBILE ROUTER Version: 1.4
5
2 Installation
2.1 Hardware Installation
Step 1: Place the WNAP 3G Mobile Router to the best optimum transmission location.
The best transmission location for your WNAP 3G Mobile Router is usually at
the geographic center of your wireless network, with line of sign to all of your
mobile stations.
Step 2: Connect the WNAP 3G Mobile Router to your wired network. Connect the
Ethernet WAN interface of WNAP 3G Mobile Router by category 5 Ethernet
cable to your switch/ hub/ xDSL modem or cable modem. A straight-through
Ethernet cable with appropriate cable length is needed. Or you can connect your
3G USB modem to WNAP USB port.
Step 3: Supply DC power to the WNAP 3G Mobile Router. Use only the AC/DC power
adapter supplied with the WNAP 3G Mobile Router; it maybe occur damage by
using a different type of power adapter.
The hardware installation finished.
2.2 Software Installation
¾ There is no software drivers, patches or utilities installation needed, but only the
configuration setting. Please refer to chapter 3 for software configuration.
Notice: It will take about 50 seconds to complete the boot up sequence after
powered on the WNAP 3G Mobile Router; Power LED will be active,
and after that the WLAN Activity LED will be flashing to show the
WLAN interface is enabled and working now.
