A-LINK WNAP4G User Manual
Chapter 7 Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the
WNAP4G Router. You can refer to the following if you are having problems.
1 Why can’t I configure the router even the cable is plugged
and the LED is lit?
Do a Ping test to make sure that the WiFi
Broadband Router is responding.
Go to Start > Run.
1. Type cmd.
2. Press OK.
3. Type ipconfig to get the IP of default gateway.
4. Type “ping 192.168.1.254”. Assure that you ping the correct IP Address
assigned to the WiFi Broadband Router. It will show four replies if you ping
correctly.
Note:
It is recommended that you
use an
Ethernet connection to
configure it
