Replace the filter into the
pump by inserting it cor-
rectly into the special
guides.
Screw firmly the filter.
Close the pump door.
CAUTION! Never remove the filter
during a washing cycle, always wait
until the appliance has finished the
cycle, and is empty.
CAUTION! When refitting the filter,
ensure it is securely re-tightened so as
to stop leaks and young children being
able to remove it.
CLEANING THE INLET HOSE AND THE VALVE
FILTER
EMERGENCY DRAIN
Because of a malfunction, the appliance cannot
drain the water.
If this occurs, do steps (1) through (8) of 'Cleaning
the drain filter'. If necessary, clean the pump.
When you drain the water with the emergency drain
procedure, you must activate the drain system
again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser.
2. Start the programme to drain the water.
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
remaining water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the emergency
drain procedure.
5. When the drain pump is empty, install the inlet
hose again.
WARNING! Make sure that the
temperature is higher than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
17
