TL-WR1043ND 300Mbps Wireless N Gigabit Router
) Note:
After a device is successfully added to the network by WPS function, the WPS LED will keep on
for about 5 minutes and then turn off.
1.4.2 The Rear Panel
Figure 1-2 Rear Panel sketch
The following parts are located on
e router to the local PC(s).
re you will connect the power adapter. Please use the
Pressing this button for less than 5 seconds enables the WPS function. If your client devices,
Pressing this button for more than 5 seconds enables the Reset function. With the router
the rear panel (View from left to right).
¾ Wireless On/Off: The switch for the wireless function.
¾ Ethernet (1, 2, 3, 4): These ports (1, 2, 3, 4) connect th
¾ Internet: This port is where you will connect the DSL/cable Modem, or Ethernet.
¾ USB: The USB port connects to a USB storage device or a USB printer.
¾ On/Off: The switch for the power.
¾ Power: The Power socket is whe
power adapter provided with this TL-WR1043ND 300Mbps Wireless N Gigabit Router.
¾ WPS/Reset:
such as wireless adapters, that support Wi-Fi Protected Setup, then you can press this
button to quickly establish a connection between the router and client devices and
automatically configure wireless security for your wireless network.
powered on, press and hold the WPS/Reset button (approximately 8 seconds) until the SYS
-5-
