If the outlet spigot has not been used before,
remove any blanking plug that may be in place.
Push the drain hose onto the spigot and
secure with a clip, ensure a loop is formed in
the drain hose (see diagram) to prevent waste
from the sink entering the appliance.
If you intend to drain the hose from the
machine into a sink, make sure that the sink is
empty and the plug hole is not blocked.
Use the plastic “U - Piece” supplied.
Important! Before connecting up the
machine to new pipework or to pipework that
has not been used for some time, run off a
reasonable amount of water to flush out any
debris that may have collected in the pipes.
Special conditions
If the floor is carpeted or covered with
crumbly or soft material, insert a rigid support
base under the feet to prevent noise, vibration
or displacement. The base should protrude a
few centimetres beyond the edges of the
appliance.
Warning! The appliance should
NOT be placed on deep pile carpeting.
Note!
Please ensure that when the appliance
is installed it is easily accessible for the
engineer in the event of a breakdown.
In the interest of the
environment
The appliance should be connected to the
FOUL drainage system, the water will then be
taken to a sewage works for treatment before
being discharged safely into a river.
It is essential that these appliances are not
connected to the surface water drainage
system as this water is discharged directly into
a river or stream and may cause pollution.
If you require any further advice please
contact your local water authority.
33
