Water inlet
An inlet hose is supplied and can been found
inside the machine drum. Do not use the hose
from your previous machine to connect to the
water supply.
Important! This appliance must be
connected to a cold water supply.
1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled
connection to the machine. Do not place
the inlet hose downwards. Angle the hose
to the left or right depending on the
position of your water tap.
45°
35°
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied with
the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Water-stop device
The inlet hose is provided with a water stop
device, which protects against damage caused
by water leaks in the hose which could
develop due to natural ageing of the hose. This
fault is shown by a red sector in the window
«A» . Should this occur, turn the water tap
off and refer to your Service Centre to replace
the hose.
A
31
