HP Markası'nın Ürünleri

136 user’s guide

To install a new optical drive:

NOTE: Make sure the jumper on the new drive is in the CS (Cable Select)

position.

1 Slide the new optical drive through the front of the computer. Don’t slide the

drive in all the way — you need room to attach the cables.

2 Connect the cables to the back of the drive(s).

3 Push the drive(s) all the way in, align the screw holes and insert the screws as

follows:

• upper drive bay, full-sized drive — use C screw holes.

• lower drive bay, full-sized drive — use D screw holes.

• lower drive bay, 3.5-inch drive in an adapter tray — use the rear (D) slotted

screw hole and the (G) forward screw hole. This positions the 3.5-inch

drive tray flush with the front cover.

NOTE: The 3.5-inch drive option applies only to Chassis I and II, and is not

available for Chassis III.

To reassemble the computer:

1 Replace the fan duct and side

panel (see ”closing the

computer” on page 139).

2 Skip this step if you are

installing a full-sized drive or if

you have Chassis III. Prepare

the front cover when a 3.5-inch

drive is in the lower drive bay:

Remove the lower bay door by

inserting a screwdriver blade at

H (5 places) on the inside of the

cover. Pry the door off the front

cover.

NOTE: This step applies only to Chassis I and II, and is not available for

Chassis III.

3 Lift the door of the CD holder located on the top of the chassis, if your

computer has one (Chassis II and Chassis III only).

NOTE: If your computer has a top door and you don’t lift the door of the CD

holder before you attach the front cover, the front cover will not fit properly

and could break, if forced.

Chassis I and Chassis II only