~
Questions?
Use This Problem Solver
~
PROBLEM POSSIBLE CAUSEAND REMEDY
..
,...
.,%.
“.*.$,..
‘<#>*if.:!&-..c
WASHEROR DRYER
● Make sure controls are p~prly ‘Set‘~d ~&er cycleselectoris pulled out or dryer ~~.
WON’TSTART
STARTbutton is pushed. . . ,,, ,.$&,, => ~~~~,
.;‘%2‘f.;.!..
%,
● Applimce unplugged. Make sure Cordis firmly plugged into electrical outlet.
● NOpower to appliance. Check f&es ndiircuit breakers to make sure appliance is
getting current.
. . . ...
.-.~.;
,,..<”?
~y:”%-
.:.”
-----
. Dryer door is open. Dryer will not ~ wi~’’d~’~~pen. Make sure washer lid k+C]O&d.
Washer will fill but will not spin with lid o~n::. -, ~
. .&.~.,:. .+
. Make sure bo~ hot and ~ld ~uce$&&&&&”~-~h~T:~.~~ ;‘~
.’, .
: ..-i .+
2-.
.,
.“”...
.,’:?...
.<
WON’T DRAIN
. Kinked or pinched hose. Check and correct.
● Topof drain outlet should be less than 8 feet abovethe floor.
WATERLEAKS
● Make sure hose connections are tight at faucets.
● Make sure end of drain hose is correc~y insefied into and secured to drain facility.
WASHERWON’T
● Lid not closed. Washerwill not progress through spin cyclewith lid up. Make sure lid
SPIN AND is closed. Lid will be automatically locked during spin portion for safety.
COMPLETE CYCLE
CL~HES ARE
● Load mayhavebeen excessive y out ofbalance. Redistribute clothes and rerun through
ABNORMALLY
final spin.
WET AFTER SPIN
APPLIANCE IS
● Me~llic “clicks” heard as timer advances during operation are normal.
NOISY
● Uneven floor. Make sure appliance is level ad fkm to floor.
● Heavi]y unbalanced loads can cause the washer to vibrate excessively during spin, and
may cause it to move from its original position. In extreme cases, (usually occurs when
washing a single, heavy item or asmall load when water level is set higher than
necessary) the spin basket may strike tie outer tub, creating aloud but harmless noise.
Tocorrect, open the lid and redistribute the load evenly about the wash basket. Close the
lid and restart.
WATERDOES NOT
. Faucets turned off. Make sure faucets are on and adjusted coITectly.
ENTER OR ENTERS
SLOWLY
● Hoses kinked. Check and correct.
● clogged screen in water valve. Unscrew fill hose from washer and clean screen if
necessary. When reassembling, make hand tight PIUS1/3turn with pliers.
18
