16
2
2
1
Important!
Ensure the rubber seal
between the drawer and
panel is kept in place.
REMOVE BRACKET FROM PRODUCT
ATTACH PANEL TO PRODUCTGROUND THE PANEL
ATTACH PANEL TO PANEL BRACKET
Important!
Use all 14 screws provided as shown.
When refitting the
door pins,
ensure they are
orientated as shown.
Align bottom of panels
with bottom of brackets
15
17
16
18
INTEGRATED MODELS ONLY - INSTALLING THE FRONT PANEL
1
2
5⁄8” (16 mm)
x14
3
1
1
2
Electrical Shock Hazard
Before continuing, ensure that the product is
disconnected from the power supply.
Failure to follow this warning may result in
electrical shock, injury or re.
WARNING!
WARNING!
Electrical Shock Hazard
To ground (earth) the panel bracket, connect
the ground (earth) wire from the product to
one of the tabs. Any custom metal compo-
nent (e.g. handle) that extends past the
rubber door seal must be grounded (earthed)
too.
Failure to follow these warnings may result in
electrical shock, injury or re.
We recommend pushing the
drawer runners back 4”
(100 mm) before attaching
the panel. Once the panel is
fiited, ensure the runners are
fully back into position and
the release tabs on both sides
are reset fully.
