15
11b 12b
13b 14b
REMOVE THE DRAWER SECURE THE DRAWER TO THE CABINETRY
REFIT THE DRAWER ONTO THE RUNNERS INTEGRATED ONLY - SECURE THE EXTERNAL VENT
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
To prevent
kinked hoses,
we recommend
rotating the drawer
anti-clockwise and
resting it on its side
after removal.
Press the release tabs
in on either side and
push back to release
drawer from runners
Push drawer runners back in.
Product may
move. Mark
chassis position
on cavity
2
1
After routing the vent hose
through and out the hole
cutout, attach and secure the
vent by tightening the four
screws provided.
Airflow
5
5
1
2
3
4
4” (100
mm)
1
2
2
The product has three pairs
of fixing points:
(Refer to
2
PARTS SUPPLIED
for relevant parts)
Ensure the sound insulation
is repositioned correctly.
a pair of fixing holes either
side on the bottom
(use 1½ ” (38 mm) fixing
screws & washers)
two pairs of formed
brackets on either side
of the chassis
(use ⁄” (16 mm) screws)
1
4
2
3
5
Ensure the drawer is
now rotated
clockwise back.
Pull forward the release tabs
on both sides 4” (100
mm)
Ensure the release tabs on
both sides are reset fully.
