88
Printer Calibration - Error Messages Description and Corrective Action
Off line: Error: BRST SNS
Press RESET to Continue
This message indicates an error
occurred, in the ZONE 3 Burst Sensor
(BRST SNS), during the sensor
calibration procedure.
This error can occur when:
• Media dust or debris obstructs the
Burst Sensor.
• The Burst Sensor cable fails or is not
connected properly.
• The Burst sensor fails.
• A component fails on the Bin 2
Controller PCB.
To correct this error:
1. Perform the cleaning procedures and
vacuum out all media dust and debris
(especially remove all dust inside the
paper guide interrupter sensor).
2. If this error continues, power the unit
off and check internal cable
connections
