22
11. Press the RESET/CLEAN key to recover from a stock empty error
message when instructed by the LCD.
Failure to fully close and lock the BIN 1 ACCESS DOOR may result
in the printer reporting a cover open condition.
To Load Stock (BIN 2):
1. Leave the printer powered on.
2. Place a maximum of 1,000 coupons at the back of the printer, directly
behind and aligned with the BIN 2 INPUT SLOT. Orient the coupons as
shown on the BIN 2 label (with the side to be printed facing up).
3. Insert the staple tab end or leading edge of the coupon (with the print
surface facing up) squarely into the document slot. The BIN 2 INPUT SLOT
has a sensor that automatically detects and loads the document.
4. Press the RESET/CLEAN key to recover from a stock empty error
message when instructed by the LCD.
Removing Coupons
After coupons are passed through the printer, the coupons are routed to the
OUTPUT BIN. The OUTPUT BIN DOOR can be unlocked with the same keys
that unlock the BIN 1 ACCESS DOOR.
Coupons are placed in one of two locations:
• OUTPUT BIN (maximum capacity of 200 coupons)
• REJECT BIN (maximum capacity of 50 coupons).
The REJECT BIN is inside the OUTPUT BIN, dropping down from the top area
of the OUTPUT BIN.
Rejected coupons may be placed in the REJECT BIN for two reasons:
• An instruction is sent from the HOST system to place the coupon in the
REJECT BIN.
• The ticket is defective and is automatically voided.
Both the OUTPUT BIN and the REJECT BIN should be checked
and emptied on a regular and frequent basis.
