Instructions for use
27
0 1. After a rinse stop, the water must first be pumped out:
– Either press the START/PAUSE (START/PAUZE, MARCHE /PAUSE) but-
ton (water is pumped out and the washing is spun according to the
position of the programme; with the RINSE STOP (GEEN CENTR.,
SANS ESSOR.) spin speed, the speed of spinning can also still be
changed during spinning),
or
– Turn Programme knob to PUMP (POMPEN, VIDANGE) and press the
START/PAUSE (START/PAUZE, MARCHE /PAUSE) button (the water is
pumped off without spinning),
or
– Turn programme knob to SPIN (CENTRIFUG., ESSORAGE) or SHORT
SPIN (KORT CENTRIFUG., ESSORAGE DELICAT) and press START/PAUSE
(START/PAUZE, MARCHE /PAUSE) button (water is pumped out and
the washing is spun or short spun).
After the end of this programme step, the END (EINDE, FIN) display
lights up.
2. Open filling door.
As soon as the display next to the DOOR/LIGHT (DEUR/LICHT, PORTE/
ECLAIR.) lights green, the door can be opened (not when the pro-
gramme security is activated. For this see „Programme security„).
3. Remove washing.
4. Turn programme knob to OFF (UIT, ARRET).
5. After washing, pull the washing agent drawer out a little so that it can
dry out. Lean door only against frame do that the washingmachine can
vent out.
3
If the display OVER DOSING (OVERDOS., SURDOSAGE)
lights up, too much washing detergent was used in the
washing program just ended. During the next wash, pay
attention to the dosing information of the washing detergent
manufacturer and pay attention to the filling quantity!
Attention! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains. (Aqua Control water protection with Aqua Alarm
does not operate if the power supply is interrupted.)
