Run wash cycle
23
During the washing program
You can at any time
– change the setting of the final spin speed,
– select RINSE HOLD,
– change the setting of the temperature.
Other settings cannot be changed.
To stop the washing program prematurely:
0 Press the ON/OFF button.
0 Turn the program selector clockwise to PUMP OUT.
0 Press the ON/OFF button again.
Washing cycle finished/Removing the washing
The washing program is completed when the ON/OFF button display
lamp goes out.
After a RINSE HOLD the water must first be pumped out or the washing
spun:
0 Either press the final spin speed/RINSE HOLD button so often until the
display of the spin speed required lights up,
or
turn the program selector clockwise to SPIN
(washing is spun in accordance with the program which has just run),
or
turn the program selector clockwise to PUMP OUT.
(water is pumped out).
0 Open the door.
0 Remove the washing.
0 Switch off the washing machine by pressing the ON/OFF button.
0 Close the tap.
0 Pull the detergent compartment out a little so that it can dry. Only lean
the door to so that the washing machine can get some air.
