Operating instructions
24
Washing Cycle Complete/Removing the Washing
Once the washing program has come to an end, (END) illuminates
on the program progress display.
If (RINSE HOLD) was selected, the indicator beside the
START/PAUSE button flashes.
0 1. After a (RINSE HOLD), the water must first be pumped out:
– Press either the (START/PAUSE) button
(the washing will be spun in accordance with the program which
has just been completed; the spin speed can also be changed during
spinning using the spin speed/ (RINSE HOLD) button),
or
– turn the program selector to (PUMP OUT), and press the
(START/PAUSE) button (the water is pumped out
without spinning),
or
– turn the program selector to (SPIN) or (SHORT SPIN),
and press the (START/PAUSE) button
(the washing will be spun or short spun).
At the end of this program step, the (END) indicator will
illuminate.
2. Open the door.
As soon as the (DOOR) indicator is green, the door can be opened.
3. Turn the program selector to (OFF).
4. Remove the washing.
5. Close the water tap.
6. Pull the detergent drawer out a little after washing so that it can dry
out. Leave the door ajar so that air can circulate in the washing
machine.
3
If the (OVERDOSING) indicator illuminates, then too much
detergent was used in the washing program just completed, and as a
result an additional rinse performed. Next time you use the machine,
observe the detergent manufacturer’s dosing instructions for the load
to be washed!
Important! If the washing machine is not to be used for a long period:
close the tap and isolate the washing machine from the mains.
