Shure T1 Body-Pack Transmitters
7
Disassembly and Assembly
25C1016 (CC)
Disassembly and Assembly
To access the printed circuit (pc) board, disassemble the transmitter.
CAUTION
Observe precautions when handling this static-sensitive device.
Disassembly
1. Slide open the battery-compartment cover and remove the bat-
tery.
2. With a #1 Phillips screwdriver, remove the four screws securing
the back of the case, and set them aside.
3. Carefully separate the top and bottom halves of the case to ex-
pose and lift out the pc board. (If you have trouble separating the
case, carefully slit the label covering the case separation inside
the battery compartment.)
Reassembly
Reassemble the T1 Transmitter as follows:
1. Presenter
T1P transmitter only: Plug the lavalier microphone
connector into J104.
2. Place the pc board in the bottom half of the case.
3. Slide the battery-compartment cover into its slot.
4. Align the rubber grommets (antenna, lavalier) while positioning
the top half of the case over the bottom half.
5. Make sure the two sections are properly seated before securing
them with the four Phillips screws.
