ENGLISH
7
HELPFUL TIPS
ADD WATER INDICATOR
If the Add Water Indicator comes on, try the following:
• Turn o the Ice Maker, add water and press the POWER Button again to restart the unit.
• There may be too much ice. Turn o the Ice Maker,
remove some ice from the Ice Basket.
ICE CUBES STUCK TOGETHER
• The ice cycle may be too long. Stop the Ice Maker, then restart it when the
ice cubes melt. Select smaller sized ice cubes using the Ice Size Button.
• The water temperature in the Water Resevoir may be too low. Change the water
in the Water Resevoir. The temperature should be set between 45˚ F - 90˚ F.
ICE MAKER NOT WORKING
If the ice making cycle seems to be running properly, but
no ice is being made, try the following:
• The ambient temperature or water temperature in Water Resevoir may
be too high. The Ice Maker must be in an environment below 90˚ F. Try
pouring colder water (between 45˚ F - 90˚ F) into the Water Resevoir.
• If changing the water or allowing the Ice Maker to cool does not work, there
may be a leakage of the regrigerant uid, or a pipe in the cooling system may
be blocked. Please take the Ice Maker to a qualied technician for repair.
LED LIGHTS
• If the LED lights on the Control Panel are blinking, tere may be a disruption in the
power source. Press the ON/OFF Power Button to stop the ice making cycle. Let the Ice
Maker sit for a few minutes to let it warm up and allow ice to fall from the evaporator
ngers. Empty the Water Tray and wait three minutes before restarting the unit.
CLEANING & MAINTENANCE
Your RETRO SERIES™ ICE MAKER should be cleaned after each use.
This will help to maintain your unit for a long time.
• Unplug the unit.
• Take out the Ice Basket.
• Clean the interior with a soft cloth using warm water mixed with a mild detergent.
• Use warm water to rinse the interior, and drain out the water by unplugging the Drain Cap.
• The outside of the RETRO SERIES™ ICE MAKER should be cleaned regularly
with a soft cloth using a mild detergent mixed in warm water.
• Dry the interior and exterior with a non-abrasive soft cloth or towel.
• When the machine is not in use for a long time, always open the Water
Drain Cap and completely drain the water from the Water Reservoir.
