23
Leica IP S
• Unscrewthe8screws(2, Fig. 8) on the sides
of the wooden box and loosen the cover.
• Removetheaccessorybox(7, Fig. 9) including
accessories and packaging material) - directly
under the lid.
• Unscrewthe8screws(3, Fig. 8) on the floor
of the wooden box on the exterior.
• Removetheinteriorcartonaroundtheinstru-
ment.
• Carefully removethe woodenboxfrom the
baseplate.
• The printerissecured with4plates (5) on
the wooden floor of the outside box. Loosen
the two screws (4, Fig. 10) on the base of the
instrument. Remove the plate from the bottom.
• Placethe printerfrom thebaseplateon a
stable laboratory bench - or, if present, on the
automated unload station. Make sure that the
stage is leveled!
Fig. 9
7
4
5
5
Fig. 10
When unpacking the printer, at least
two people (one person on each side
of the printer) are required to lift the
printer out of the box and place it onto
the laboratory bench.
Fig. 11
6
• Iftheinstrumentwassetupatitsfinalareaof
use, remove the blue foam transport anchor
(6, Fig. 11) (pull upwards).
4. Instrument Setup
