TD 92675EN
20 June 2012 / Ver. E
Configuration Manual
Ascom i62 VoWiFi Handset
11
4. Installation of VoWiFi
2 Click “Device Manager“.
3 Select the Numbers tab and click “New“. The New n
umbers window is opened.
4In the Device Type and Pa
rameter version drop-down lists, select the device type and
the parameter version to use, respectively.
NOTE: The device type and parameter version must match th
e handsets to be used to apply
the template.
5In the Prefix field, ent
er the numbers’ prefix (if needed).
6 Create a range of numbers by selecting the “
Range“ option. Enter the start call
number and the end call number in the fields, respectively. Click “OK”.
NOTE: The maximum range that can be added at a time are 100 numbers.
7 Apply the network settings template to the selected handsets. See 4.4.2 Apply a
Template to a Handset with a Number on page 14.
8 Apply the common settings template to the selected handsets. See 4.4.2 Apply
a
Template to a Handset with a Number on page 14.
9Close the IMS3.
4.1.4 Create a Network Template with Initial Configuration in the PDM
In a
factory delivered handset, the WLAN settings ar
e not configured that is required to
access the IMS3. Using the PDM allows the handset to be primed with the WLAN parameters
and allows it to log in to the Device Manager in IMS3 for future management over the air.
Create a template with the basic network settings and IP address to IMS3. This template is
only used once for each handset since it must access the WLAN and then log on the Device
Manager. After log in, the settings in the handset are changed according to the templates in
the Device Manager in IMS3.
1 Open the PDM.
2 Do one of the following:
• If a network template was created in the Device Manager in IMS3, export this
template and import it to PDM. See Appendix
A for more information.
(Recommended)
• Create a template (see 4.4.1 Create a template on page 14) with the following
network parameters:
- Network settings
a
(located under Network > Network A (B, C, or D)
- Unite settings
b
(located under Device > Unite)
Note: The parameters in this te
mplate should be identical to the parameters
in the network template created in the IMS3.
3 Put the handset in the Desktop Programmer (DP1) cradle.
4 Run the template. See 4.4.3 Apply a Template to a Handset without a Number on
page 14.
5 Remove the handset when synchronization is finished.
6 Enter the Number and the password
1
(if any). Press “Login“.
a. All required system settings for the WLAN. For example SSID and Security mode.
b. IP address and password (if a
ny) to IMS3.
1. The password is only required if the “Password“ parameter is set.
