Dil ID: 14
Dil Adı: sloavakia
Dil Kodu: sk10tayfun Produkty značky Alphatech
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



NLLW návod k obsluze a instalaci
14
2.2 Calling from LLW
The functionality of LLW is influenced by connection of further lift
components (failure notification, relay,...) as same as by setting of LLW
parameters (via. chapter Chyba! Nenalezen zdroj odkazů. Chyba!
Nenalezen zdroj odkazů. / pageChyba! Záložka není definována.).
2.2.1 Emergency call (button activation)
The emergency call is basic and most important feature of LLW. It is
activated by button pressing (screw BTN). To provide correct functionality you
must keep 2 conditions:
First condition is that , button blocking is not active. Please note that
blocking might be either by leading voltage 5-24V or by disconnection this
voltage.
Second condition is that button you must hold enough time. It is
adjustable from 0,5 sec to 5 sec.
Button pressing has priority before other calls (service, failure even
incoming). If is being a call ( not emergency) the call is stoped and starts
emergency call procedure.
During emergency call is active both way voice communication. During
establishing call is lighting yellow indicator . After call connection call
confirmation – green indicator light up.
Emergency call dial progressively stored numbers (1÷6 position). It starts
from position 1 up to position which is not programmed. It means when you
program numbers to all 6 position then progressively dial all 6 numbers. When
you erase number on position 3 then dial numbers on position 1 and 2 and
returns back to position 1. You can also program how many times the round
(programmed numbers on position 1-6 should be repeated ( 1 to 5 times).
While is emergency call the button does not react on other pressing and even
more any other stage might not break emergency call procedure.
The machine room call only can break emergency call (chapter 2.2.5
page.16). The last point of emergency call is call confirmation. At every
emergency number (position 1-6) you can select confirmation or not.
(chapter 2.2.4 – page.15.). Dialing is stopped after call connection.
2.2.2 Calling from INP1 activation (failure)
Calling from activated input INP1 is named failure calling. The LLW
enables to make notification about lift failure for service department. The call is
activated by voltage change ( 5-24V ON/OFF) on input INP1. It is adjustable in
setting. As follow you can select time how long must be change on input INP1
to start failure calling.
Failure calling has own number which might be of course the same as
emergency or service call number. You can also select if will be dialing only
this number or all round of emergency numbers ( then you have max 7
numbers) .