Section 2 System Overview
2-7-1 Fluorescent Light Observation Procedure
Start the system.
Prepare the system
(tum on the power supply).
Introduction to Fluoview (2-6)
Start the Fty<M/iew software.
Op9fati«>n(
2-1-1)
Look through the eiej^Hnti J^ns and focus on the speclmea
ISelect the li^pf^for
100%
for binocular
tube and
feiCttSidn
the specimen.
Har<iW»e(S-l-1)
•
Set to thft LSM light
path.
Set to the tSM light
path.
Hardware (3-1-2)
Set ^ scan unit.
[
Operate the det^t^tion mode setting
knob and^et the channel.
Har<IW8re(
3-1-4)
Insert the absorptK«t filter into the light
path!
Har<tware(
3-1-5)
Operate the pinhole turret and
se{.dd a pinhole.
Har(JWB(re(
3-1-3)
Operate th6 ND filter turret and
seled;*
ND filter
(100%.
50%, 20%, 6%).
.H^tJware
(3*1-6)
'••"• • --••• •)*-«••«•»'+ fy^yy^^ifr^i'^-^*
i
Replace with a high transmt^lifQn
rate ND filter (100%, 50%, 20%»6%).
Hardware -,
(3-1-6) . . ,
Read in an image.
Operation (3-1)
Set the ot)$en/ation
conditions.
\i
Scan once
<H:
repeatedly.
If the image is
not displayed,
•
adjust In
accordance
with the
;
The
imagels \
•
dsplayediofe^ ;
!software[Uv8] >
!
panel.
!
If^ima^jefs.
not dis{)layad.
( Adjust the PMt voltage, ^\
V lllll r [ f
tltspl«^ed.
iC
stop scanning.
I *M -It 4i * I
Shut down the system.
Shut
doWCi
the Ruoview software.
,
<;^>eration(
2-1-2)
•*:*•«
•«*(••
Shgl down the system.
(Tum off the power supply.)
2-15
