Chapter 6 Access Point Mode
WAP3205 User’s Guide
46
6.3.1 Setting your WAP3205 to AP Mode
1 Log into the Web Configurator if you haven’t already. See the Quick start Guide for
instructions on how to do this.
2 To use your WAP3205 as an access point, go to Maintenance > Sys OP Mode
and select Access Point mode.
Figure 21 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As
soon as you do, your WAP3205 is already in Access Point mode.
6.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
1 Connect your computer to the LAN port of the WAP3205.
2 The default IP address of the WAP3205 is “192.168.1.2”. In this case, your
computer must have an IP address in the range between “192.168.1.3” and
“192.168.1.254”.
3 Click Start > Run on your computer in Windows. Type “cmd” in the dialog box.
Enter “ipconfig” to show your computer’s IP address. If your computer’s IP
address is not in the correct range then see Appendix C on page 149 for
information on changing your computer’s IP address.
4 After you’ve set your computer’s IP address, open a web browser such as Internet
Explorer and type “192.168.1.2” as the web address in your web browser.
Note: After clicking Login, the Easy mode appears. Refer to Section on page 35 for
the Easy mode screens. Change to Expert mode to see the screens described
in the sections following this.
