
9
Prior to Using for the first Time
Do the following steps before using your dishwasher
for the first time.
Fill with rinsing aid
1. If the display lamp is lit, open the dispenser by turn-
ing the sealing cap (A) to the left.
2. Fill with rinse aid up to the ”max.” marking (B). Do
not exceed the maximum container quantity of
150 ml!
3. Close the dispenser.
4. Immediately remove any spilled rinse aid, as
otherwise foaming can occur.
The rinse aid display goes out.
Setting the rinse aid
dosage
1. Open the dispenser (A) by turning the sealing cap
to the left.
2. To increase the dosage (B), turn the dosage arrow
to the left using a coin or a screwdriver. The factory
setting is Level 3 (ideal setting level 2 – 4).
3. Close the dispenser.
On this topic, please also take note of the ”Remedying
Faults” page 24 chapter.
Filling the salt
dispenser
Never fill the salt dispenser with rinse aid or
detergent!
Use only special dishwasher salt in your dishwasher.
Fill with salt as follows:
1. Open the cap (A) of the salt dispenser.
2. Fill the dispenser with water (B).
3. Fill with 1 kg of special salt (C). As a result, approx.
1 litre of water will be displaced.
4. Remove salt from around the opening of the dis-
penser.
5. Close the salt dispenser by turning the cap until the
stop is reached.
6. Immediately run a wash program except the
”Pre–wash” to wash away any salt residues.
The salt display will go off after 1 or 2 rinse cycles.
Do not remove the water feed valve, and do not
fill with detergent for any reason.
A
B
C