Whirlpool is a registered trademark of Whirlpool USA
5019 396 01169
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1
GB
WP 85
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to
different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness
and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:
for more detailed information on
the EN comparison test and other
tests, contact the following address: “[email protected]”.1. OVERVIEW
ON button
OFF button
Fault indication and wash time display
With “Delayed start” selected it indicates the time
remaining until programme start (hh). Toward the end of
the programme, during the drying cycle, the display will
indicate the time remaining in minutes.
In the presence of a fault indication “F.” –, consult section 5
“What to do if...”.
The acoustic signal continues to sound as long as the error
persists.
Delayed start” button
Press the button (repeatedly) to delay the start of the
programme. Adjustable from 1 to 24 hours. With each
press of the button, the delayed start indicator increases by
one hour and after 24 restarts from 00. Then press the
START button. The dishwasher will start after the set time.
Detergent setting upon initial use and when using a different type of detergent
1. Press and hold down the programme Selection button; also press the
Delayed Start button. The type of detergent last selected will be
shown on the display.
2. With the Delayed Start button, set the required detergent
(“--” = powder, “2 l” = 2 in 1, “3 l” = 3 in 1, “A l” = all the other combined
detergents) (in this way the rinse aid and salt level indicator lamps are
deactivated). The type of detergent selected will be shown on the display.
3. The type of detergent set is memorised after 5 minutes or on switching off the
dishwasher. It is shown on the display for about 3 seconds after switching on.
Bear in mind that the required programme can be set, possibly selecting
delayed start, only after having changed the type of detergent.
Programme selection button
Press the button repeatedly until the desired programme
indicator lights up.
START button
The indicator lights up during operation, flashes when a
fault occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected
programme and options are cancelled. Main failure
displays (repeated flashing of the START indicator lamp)
can be cancelled by RESETTING. Detailed instructions
are given in chapter 5 “What to do if...”.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Available
options
Loading instructions large small Litres kWh Minutes
1
Pre-Rinse cold
Crockery to be washed later. — — 4.0 0.03 14 ±
1)
2
Quickwash 45°C
Lightly soiled crockery, without dry
residuals.
X — 11.0 0.80 30 ±
1)
3
Eco
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X X 12.0 1.05 165 ±
1)
4
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.
X X 14.0 1.55 155 ±
1)
5
Half Load 50°C
Ideal for washing a half load of lightly
or normally soiled crockery.
X X 10.0 1.04 145 ±
1)
