Whirlpool is a registered trademark of Whirlpool USA
5019 396 01120
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1
GB
WP 75
1) Programme data obtained in conformity with European standard EN 50242. The data may vary according to different loads,
different extra functions, different sensor settings (for sensor programmes only), different water supply temperatures, different
water hardnesses, different power supply voltages, etc.
2) Reference programme for energy label in compliance with EN 50242. - Important information for Test Laboratories:
for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with.
Standard NF EN 13697 - November 2001.
1. OVERVIEW
On button
Off button
Programme selection button
Press button P (repeatedly) to bring up the number of
the desired programme on the display.
Time and failure display
With normal operation, the display indicates residual
time (h:mm), while with the “Delayed start” function
selected it indicates time remaining until the start of the
programme (hh).
If “F..” appears on the display, see chapter “5. What to do
if...”.
Rinse aid level indicator and salt level indicator
These indicator lamps light up when rinse aid or salt
need to be added. Add just before starting a wash
programme.
Select detergent
Press the button repeatedly to select the type of
detergent used.
This deactivates the rinse aid and/or salt indicator lamp.
Half Load/Multizone Button
The half load cycle can be used for the upper or lower
rack. Select the required programme then press the “Half
load” button. The light comes on and goes off at the end
of the programme. This function can be used with the
programmes indicated in table 1.1.
Powder, gel, tab (standard): indicator off
Detergent with rinse aid: left indicator
Detergent with salt + rinse aid: right indicator
Antibacterial rinse
3)
This function activates an antibacterial rinse at the end of
the wash cycle, guaranteeing a further reduction of
bacteria. Press the button to activate or deactivate the
function. This function can be used with those
programmes marked with the relative symbol in table 1.1.
The dishwasher door must be kept shut for the entire
duration of the programme in order to guarantee
reduction of bacteria. If the door is opened the indicator
lamp starts flashing.
“Delayed start” button
Press the button repeatedly to delay the start of the
programme. Delay adjustable from 1 to 24 hours. With
each successive touch of the button, the delayed start
indicator increases by one hour and after 24 returns to
00. Then press the START button. The dishwasher will
start at the set time.
START button
Switches “on” when the dishwasher is operating. Flashes
when a fault occurs. Switches off at the end of the
programme.
Reset button - for changing programme or failure display
Press this button to cancel a started programme and
selected options. Press this button to cancel the main
fault indicators (F..), for fault details consult chapter “5.
What to do if...”. A new programme can then be selected
and started.
Table 1.1.
Programme chart
Detergent
dispenser
Consumption
1)
P
Programmes
Selectable
extra
functions
Loading instructions large small Litres kWh Minutes
1
Pre-Rinse cold
Crockery to be washed later. — — 5.0 0.02 10 ±
1)
2
Quickwash 40°C
Lightly soiled crockery, with no
dried-on food.
X — 13.0 0.70 30 ±
1)
3
Eco
2)
50°C
Normally soiled crockery. Energy
saving programme.
X X 15.0 1.05 165 ±
1)
4
Daily 60°C
Normally to heavily soiled crockery. X X 16.0 1.35 120 ±
1)
5
Intensive 70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.
X X 17.0 1.65 145 ±
1)
