9
LIQUID DETERGENT DISPENSER (OPTIONAL)
In the detergent dispenser (1) the minimum flow rate is obtained by turning the adjustment screw anti-clockwise, while the
maximum flow rate is obtained by turning it clockwise; bear in mind that 1 g. of detergent takes up a volume of approximately 8
cm of hose.
Make sure the RED product intake hose is inserted into the detergent tank and that the little filter has been installed as well as
the weight on the hose (2).
For the type and quantity of detergent to use, ask your supplier of chemical products.
Too much detergent will not only generate foam in the wash tank, but will also leave the dishes streaky.
4 - PREVENTIVE CHECKS
Check the following before using the dishwasher:
WATER LEVEL
While the wash tank is filling, the water should stop flowing when its level is at least 1 cm. from the spill level of the overflow
device.
The filling solenoid valve should start to work again when the level of water is 2 cm. above the heating element in the tank.
WASHING AND RINSING ARMS
The washing and rinsing arms must turn freely without any interference and all the nozzles must work correctly.
TEMPERATURES
The temperatures of the rinse and washing water must be those written on the table.
DISPENSER
For each cycle, the dispenser should intake the correct amount of rinse aid and/or detergent.
WASHING RESULTS
The washing results should ensure that every possible trace of solid waste has been removed from the surface of the dishes.
At the end of the cycle, the perfectly clean dishes should dry in a couple of minutes through evaporation once the basket is
taken out of the machine.
5 – OPERATIONAL INSTRUCTIONS
Open the
mains water
cock (utility).
Switch the main
ON/OFF switch on
(utility)
the level of
detergent and rinse
aid in the
containers.
that the filters are in the correct position, the spray arms
turn and that there are no foreign bodies in the
dishwasher.
Make sure the overflow sits in the drain hole properly
5.1 – DAILY USE FOR MODELS STANDARD AND ECO
The panel shown in the manual and in the graphics may
contain functions which are not present on your machine..
What to do and what happens
Activate the wall switch, open the door, insert the overflow and close
the door:
Press the on/off button. The boiler and tank water-loading led
indicator light turns on. Once the boiler and tank have been loaded,
the boiler led indicator light turns on.
