Reboot
Reset to Defaults
Antenna alignment Tool
Wireless Site Survey utility
Device Discovery
Reboot: activate Reboot control in order to initiate full reboot cycle of the device. Reboot
effect is the same as the hardware reboot, which is similar to the power off - power on
cycle. The system configuration is not modified after the reboot cycle completes. Any
non-applied changes will be lost.
Reset to Defaults: activate Reset to Defaults control in order to initiate reset the device
to factory defaults routine. Reset routine initiates system Reboot process (similar to the
power off - power on cycle). The running system configuration will be deleted and the
default system configuration (all the system settings with no exception) will be set.
After the Reset to Defaults routine is completed, AirOS system will return to the
default IP configuration (192.168.1.20/255.255.255.0) and will start operating in
Station-Bridge mode. It is highly recommended to backup the system configuration
before the Reset to Defaults is initiated.
Support Info: activate Support Info button in order to get system information file. This
file should be provided to Ubiquiti support engineers (upon the request) while
investigating all the technical support or configuration issues if any.
[Content]
Tools
Align Antenna
Align Antenna utility allows the installer to point and optimize the antenna in the direction of
maximum link signal.
Selection of the Align Antenna tool will open new window with signal
strength indicator. Window reloads every second displaying the signal
strength of the last received packet.
Horizontal/Vertical: displays the received wireless signal levels for each
polarity, while operating in Station (or Station WDS) mode on MIMO 2x2
devices. Signals Strength is measured in dBm.
"'Noise Level"': value displays the value of the noise level wireless signal was
received.
The "Max Signal" slider bar allows the range of the meter to be either
increased or reduced. If the range is reduced, the color change will be more
sensitive to signal fluctuations as Max Signal slider actually changes an
offset of the maximum indicator value thus the scale itself.
Align Antenna window can be closed with the Close this window button.
Site Survey
Site Survey: utility will search for wireless networks in range on all the
supported channels while device is operating in Access Point or Station mode. In
Station mode channel list can be modified. Refer to the section Link Setup for
the details on channel list customization.
Site Survey reports MAC Address, SSID, Device Name, Encryption type (if
any), Signal Strength/Noise, dBm, Frequency, GHz and wireless channel of
all the surrounding Access Points which can be found by the AirOs based
device.
The Site Survey can be updated using the Scan button. Site Survey window
can be closed with the Close this window button.
Device Discovery
This utility will scan for all Ubiquiti Network devices within the network the
device is a member of. The search field will automatically filter devices
containing specified names or numbers, as you type them.
Device Discovery: shows device MAC Address, Device Name, Wireless Mode,
SSID, Product type, Firmware version and IP Address. To access a device
configuration through his Web GUI, click the device’s IP Address.
The Discovery can be updated using the Scan button.
Ping
AirOS 5.3 - Ubiquiti Wiki
http://www.ubnt.com/wiki/AirOS_5.3
31 van 34 14-4-2011 21:46
