PROBLEM
Dishes not dry
Spotting and
filming
CAUSED BY
=Water is not hot
=NO HEAT DRY
option selected
=Improper loading
oRinse agent
dispenser empty
°Hard water
-Water is not hot
.NO HEAT DRY
option selected
=Not enough or
poor quality
detergent
-Old detergent
=No rinse agent
SOLUTION
. Raise water heater thermostat to 140°F if
necessary.
• Do not select NO HEAT DRY option.Allow
dishes to dry in heated air.
• Load dishes so items drain properly. Avoid
overloading.
=Fill rinse agent dispenser if empty.
oFill detergent cups to capacity. Use dishwasher
detergent with highest available phosphorous
content. May be necessary to install a water
softener,.
.Raise water heater thermostat to 140°R
-Drying without heat may cause some
spotting. Do not select NO HEAT DRY option.
. Use more fresh automatic dishwasher
detergent. Use detergent with highest
available phosphorous content,
especially if you have hard water,
=Use only fresh, automatic dishwasher
detergent. Store tightly closed in a cool, dry
place. Discard old, lumpy or separated
detergent° Do not fill detergent dispenser
until ready to wash
, Fill rinse agent dispenser.
To remove stubborn spots and film from
glassware:
t. Remove alt metal utensils from the
dishwasher..
2. Do not add detergent.
3., Select POTS PANS cycle,,
4, Start the dishwasher and allow to run for
t8 to 20 minutes. The dishwasher will now
be in the main wash°
5. Then open the door and pour 2 cups
(500 ml) white vinegar into bottom of
dishwasher.
6. Close the door and allow to complete the
cycle.
If vinegar rinse doesn't work: Repeat as
above, except use 1/4 cup (60 ml) of citric
acid crystals instead of vinegar. (Most
drugstores carry citric acid crystals.)
t7
