
SECTION 2
PRINTER INSTALLATION & SETUP
Loading Media
When placing media into the printer, it is important to follow these steps.
1. Start by placing a single piece of media into the
feed section, so that it is touching or starting to
feed under the sheet separators.
Figure 22
2. Before adding media; fan the stack of material so
the bottom pieces are closest to the separation
point, as shown in Figure 22. Then carefully place
the stack between the side guides, so the leading
edge of the stack is against the sheet separators, as
shown in Figure 23.
3. Additional pieces can be placed onto the stack, as
described in the above step.
Figure 23
4. If the printer runs out of material, be sure to reload
the printer beginning with the first step.
18
Envelope Imager 3.0/4.0 Operations Rev. 6/7/2007