Dual In-Line Memory Module (DIMM) 10-5
3 Using a screwdriver, remove two
screws.
4 Slide the panel slightly to the
down and lift it off the printer.
5 Insert the DIMM at an angle
(about 45°) into the connector,
making sure that the notch on
the unit aligns with the tab on
connector, and then press down
carefully until it clicks into place.
" Be sure to handle the
DIMM by the edges only.
" You will hear a click when
the DIMM is properly
placed.
6 Reinstall the panel and tighten two screws.
7 Attach the back cover and tighten four screws.
8 Reconnect all interface cables.
