Digicast Media Router S2 Receiver CMR-5975 (MR-S2) Revision 3
Introduction MN-CMR5975-IOM
1–2
Figure 1-2. Digicast Media Router S2 Receiver – Rear Panel
1.2 Standard Features
Based on an embedded architecture, utilizing a FreeScale MPC859 CPU and eCOS Operating
System, the MR-S2 provides the following features:
• High Reliability
• DVB-S and DVB-S2 L-Band Input
• Ethernet Output rates as high as 83 Mbps (1,500 byte packets)
• Support for Multicast and Unicast IP datagrams
• Supports the decapsulation of MPE
• MPE Section Packing and Non-Section Packing on a PID-by-PID basis
• Supports encapsulation of transport streams over IP
• Support for all valid PIDs in 8192 range
• 64 PIDs
• MPEG-2 188/204-byte operation
• Support for 802.1Q VLAN Tags
• IGMP for Multicast Route Announcements
• Redundancy
• Configurable Telnet and HTTP ports for security
• Color LEDs for status monitoring and rapid fault isolation
• Management (monitor, control and configuration):
Web Interface
TFTP for field software/firmware upgrade
Terminal Interface
Telnet
SNMP V2 (Private and MIB II) Support
Vload
