WIRING
69
WIRING Impala
Wiring Provisions for Vehicle Grille Lamps, Flasher and Speaker/Siren – SEO 6J3
A. Blunt cut ends for the Alternating Signal Flasher, Customer-
Furnished Grille Lamps and Customer-Furnished Siren/Speaker
B. Control Wires from In-Line Connector in Forward Lamp Harness for
Customer-Furnished Grille Lamps and Speaker
This wiring provision option consists of one 16 gauge (1.0 mm) wire
connected to an alternating signal flasher located underneath the
instrument panel on the passenger’s side. Five feet (1.5 m) of extra wire
from the flasher is routed from underneath the instrument panel to an
area behind the grille. All four wires have 12 inches (30 cm) of extra
wire in a coil behind the grille. Grille lamps and the speaker are not
included. The flasher is not included when SEO 6J7 is ordered without
SEO 6J3.
The SEO 6J3 wiring provision also includes control wiring for the SEO
6J7 exterior lamps emergency flashing system. A dark green/red 18
gauge (0.8 mm ) headlamps flasher module control wire activates the
flashing system when 12-volts are applied.
When SEO 6J7 is installed without SEO 6J3, only the dark green red
control wire is provided for connection to customer-furnished 12-volt
switching to turn the emergency flashing system on or off.
ALTERNATING SIGNAL FLASHER
WIRING HARNESS WITH
ALTERNATING SIGNAL FLASHER
