WIRING
65
Blunt cut ignition controlled power and signal circuits are also included in
the following 5 ft (1.5 m) right foot loop:
• A yellow, 20 gauge (0.5 mm
2
) 10 amp fused circuit, Hot in
ACCESSORY, RUN or RAP (Retained Accessory Power)
• A pink, 20 gauge (0.5 mm
2
) 10 amp fused circuit, Hot in START
and RUN
• A yellow/black, 20 gauge transaxle park signal from the Body
Control Module (BCM). The circuit provides a switched power when
the transmission is not in PARK (P) or NEUTRAL (N) and the ignition
is turned to ON. The electrical load attached to the park circuit must
not exceed 0.5 amps and is meant to drive one relay coil.
• A brown, 22 gauge (0.35 mm
2
) vehicle speed signal (4,000
pulses/mile) from the ABS module. Connect only high impedance
load.
The spotlamp fuses are located in the passenger’s side underhood fuse
block.
See
“Fuses and Circuit Breakers”
in your owner’s manual index for
more information.
WIRING Impala
CONTROLLED POWER AND SIGNAL CIRCUITS WITH 12 VOLT POWER SUPPLY
