IMPALA
25
DESCRIPTION OF OPTIONAL SPECIAL EQUIPMENT
IMPALA 9C1 AND 9C3 POLICE PACKAGE -
(continued)
6F5 WIRING - ROOF
This is a universal roof wiring harness for roof-mounted equipment. Two
10 gauge blunt cut wires are color coded with three feet of extra wire
coiled under the instrument panel and 2 feet coiled outside the roof.
Roof wiring is extended through roof hole, secured and sealed with a
rubber grommet.
When 6J5 right side hole is ordered, the wires extend through the roof
on the right side. When 6B7 center hole is ordered, the wires extend
through the roof, at the center line.
SPOTLAMPS
AND SPOTLAMP PROVISIONS
7X6 Spotlamp Left Hand, pillar-mounted Unity, 6 inch with
replaceable H3 halogen bulb; independently fused
7X7 Spotlamps Left- and Right-Hand, pillar-mounted Unity, 6 inch
with replaceable H3 halogen bulb; independently fused
7X8 Spotlamp Provision Left-Hand provision for customer installed
spotlamp includes hole through pillar, mounting bracket and
accessible power connector
7X9 Spotlamp Provision Left- and Right-Hand includes same
components as option 7X8
NOTE: Lamp fuses are located in the engine compartment electrical center.
HOLE IN ROOF PANEL
6B7 Hole is drilled near center line of roof panel
approximately 29 inches rearward of windshield
opening
6J5 Hole is drilled on passenger side of roof panel
approximately 29 inches rearward of windshield
opening and approximately 6 inches inboard from
passenger side door
NOTE: Only one roof hole location may be ordered. SEO 6F5 roof wiring
is required when SEO 6B7 or SEO 6J5 are ordered.
NOTE: Wiring diagrams for these options are shown in the Police Package Owner’s Manual Supplement (shipped in glove box).
