40. Firmly grasp the air intake box and pull
up removing it from the vehicle.
41. To prevent expansion foam from
escaping, insert the black plastic plug
supplied in the hole located in the upper
edge of the right (passenger) side wheel
well.
42. Locate the can of expansion foam in your
kit. Follow the directions on the back
of the can. Insert the end of the straw
into the hole and dispense the foam into
the hole for 10 to 12 seconds. In the
existing hole that is just to the rear of the
slot that the coolant tank sits in, again
dispense the foam into the hole for 10
to 12 seconds. You will not need the
entire can. Do not attempt to over fill the
fender. (Note: do not disturb foam for
8 hours.) Noise levels will be drastically
reduced when foam has set.
43. Using a long pair of pliers, remove the
coolant hoses from the bottom of the
throttle body.
