15
Safety instructions when connecting to the gas sup-
ply
1 Warning!
When installing, the appliance must not be connected to the electrical
supply. Disconnect the mains plug or switch off or take out the fuses.
Shut off mains gas supply.
• A stop tap must be built-in between the house’s gas supply and the
appliance.
• Before connecting the appliance, check whether the local connection
conditions (type of gas and gas pressure) match the appliance’s set-
up.
• The settings for this appliance are given on the appliance’s rating
plate.
• The present settings for the type of gas and gas pressure are given on
a sticker near the connection pipe.
• This appliance is not connected to an exhaust gas outlet. It must be
connected in accordance with the installation conditions that apply.
Special attention is to be paid to suitable ventilation.
Gas connection
• The 1/2’’ gas connection pipe is located on the left-hand side of the
back of the appliance.
• Burner rail end piece with nut (1),
gasket (2) and adjustable fitting
(3) are to be assembled as illus-
trated.
• It is recommended that a gas
safety socket is used.
• The connection can be permanent
or using a permitted gas safety
hose assembly with a socket.
• The hose assembly must be posi-
tioned such that it is not in con-
tact with anything and must not
come into contact with a move-
able part of the built-in unit (e.g. drawer).
• The gas hob can be changed over to other types of gas. Conversion
kits for other gas types are available in specialist shops.
