25
IR EMITTER
NetCommand REPEATER
RIGHT LEFT
VGA VIDEO
640 x 480 60Hz
VGA OUTPUT
White
Red
White
Red
Connecting MonitorLink™ with MonitorLink Control or DVI
Computer with a VGA Monitor
Figure 15
1. Connect VGA Monitor Out from the computer to VGA
Input on the TV back panel using a VGA compatible
monitor cable. See Appendix B for signal compatibility.
2. Connect the L (left) and R (right) audio cables from
the computer to VGA AUDIO on the TV back panel.
In cases where your computer’s audio output is a
single mini- jack, a splitter is needed to complete this
connection.
Note: To utilize the benefits of a digital A/V receiver,
connect your computer’s digital audio out, if available,
to a digital input on your digital A/V receiver.
CAUTION: To ensure continued FCC
compliance, the user must use a shielded
video interface cable with bonded ferrite
cores when using the VGA input, and with
bonded ferrite cores at both ends when
using the MonitorLink/DVI input.
Figure 14. Connecting MonitorLink/DVI
Figure 15. Connecting a Computer with a VGA Monitor
MonitorLink and MonitorLink Control
Figure 14
1. Connect a MonitorLink cable from the Mitsubishi
Receiver/Controller back panel to the TV back panel.
2.
Connect the L (left) and R (right) audio cables from
the Mitsubishi Receiver/Controller to AUDIO LEFT and
AUDIO RIGHT on the MonitorLink section of the TV
back panel.
3. Connect the MonitorLink Control cable from the
Mitsubishi Receiver/Controller back panel to the TV
back panel.
External DVI Device with DVI-HD
Figure 14
1. Connect a DVI cable from the DVI output of the
external DVI type device to the MonitorLink/DVI-HD
input on the back of the TV.
2. Connect the L (left) and R (right) audio cables from the
external DVI device to AUDIO LEFT and AUDIO RIGHT
on the MonitorLink section of the TV back panel.
NOTE: When used as a DVI Input, MonitorLink
input is compliant with HDCP and the EIA-861
standards for standard, extended and high definition
video. This input is not intended for use with
personal computers or devices outputting video
signals with computer resolution.
Connecting a Computer with a VGA Monitor
To prevent uneven phosphor wear from
computer generated still images, turn on your
computer’s screen saver feature and set to 5
minutes or less.
IMPORTANT
